So just on playing with my newly acquired rapid and had to turn it down a tad as it was a little warm, consistent though, not a standard end cap on it so does anyone recognise who might have done it? Spring has a guide on each end and a washer which I've now removed to drop the power down. More testing and pellet testing tomorrow, also managed to get my sightron 3-16x42 ffp mrad scope back to go on it. Very happy ;D
Brett
seen a few like this could be anyone with a lathe, Steve peg use do some like this but his plugs were made from brass
KevG
Cheers Kev, just wondered who had done it and maybe if they'd been inside doing anything, haven't looked properly yet, seems nice and consistent. I'll be trying it out properly in the morning. Thanks again.
Brett
I've made a few blank ones what you just thumb in,some one could have drilled holes in one of those
kevG
Hey KevG....
Use a Rotary Broach on it !!
it will make a round hole into a hex, so an allen key can fit!
(https://photos.imageevent.com/scl_electronics/misc/taigstuff/websize/Rb1.jpg)
Made this little guy from Hemingway kits from your side of the pond!
It has a slight 7 degree angle milled in the body. So as it spins, it actually wobbles.
As you apply force on it, it will slowly pound the cutting edges through!
You can make you own bits on rotary table.... or use commercially sold ones..
The results....
(https://photos.imageevent.com/scl_electronics/misc/taigstuff/websize/RotaryB1.jpg)
(https://photos.imageevent.com/scl_electronics/misc/taigstuff/websize/Test1.jpg)
(https://photos.imageevent.com/scl_electronics/misc/taigstuff/websize/Test2.jpg)
A little video of it in action......
https://photos.imageevent.com/scl_electronics/misc/taigstuff/rotary%20broaching.mp4
For the Apple Guys....
https://photos.imageevent.com/scl_electronics/misc/taigstuff/rotary%20broaching.mov
Stuart
yes ive done them like that to Stuart i just do the plain ones sometimes as I think they look more tidy, all you need is a bit of rubber glove on your thumb to grip and twist them in.also made some out of black delrin as they look just like an anti tamper
kevG
Oops,,,,, ??? ??? ??? ??? ??? ??? ???
I forgot what side of the pond you live on!!!
Good Call!... that would help conceal the it was adjustable!!
Or make a slightly thinner hammer adjust screw... Then have a threaded plate behind that to hide it.....
oh well.....
Have a nice one M8...
Stuart