Hi all - following on from my other thread "Look what I've found", well I found another one ;D So now the next project is starting....
- Dr Bob is already sorting out the bits for me on the internal side of things...this block is as bare as a bare thing so absolutely everything is needed
- Kev is making me a MFR reg - the cylinder will screw nicely onto this.
- Other bits and pieces are coming together.....
(https://i.imgur.com/NHUyVtX.jpg)
Nice! Another lefty?
Yes sir.
ime sure it will look great Tim,whats the fill pressure on the tube
KevG
Quote from: KevG on January 31, 2022, 10:50:19 AMime sure it will look great Tim,whats the fill pressure on the tube KevG
No idea Kev - haven't looked.
Its an original GSX100 tube from Impact Air - I need to look on the tube, or I'll check with Chris. I'll only fill to 200 like all my other rifles, so it should cope with that.
normally those are 200 bar
KevG
Perfect. :D
Very Nice!
Looks like your Project is off to a Stellar Start!
Good Luck and Keep all of Us posted on it's Prgress
Stuart
Looking good Tim, this is going to be a great build 8)
So that's what you are up to
HI Tim.
I'm just on with the bolt assembly now remind me of the calibre probes required??
Bob
.177 please Bob. I have a nice EV2 barrel for it ;D
Just finished but missed the post, so all the bits you need to build it will be in the post tomorrow. A step-by-step photographic guide of the project, please :).
Bob
I'll try ;D
So Kev and Dr Bob have never let me down, and they have done it again......2 packages arrived today......
Just waiting on the final bits and pieces, then I'll stick a thread up ;D
sure it will look spot on when its finished, here is mine on the same airtube
KevG
Like the shroud on that Kev - very nice. I ended up with a CS stock as it was cheaper than what Chris wanted of ran original....he wouldn't sell me his spare stock ;D
I had a spare stock(in picture)was mint,sold it not that long ago
KevG
Yep built mine a while back 👍
Quote from: Tim_B on February 03, 2022, 12:41:06 PM
So Kev and Dr Bob have never let me down, and they have done it again......2 packages arrived today......
Just waiting on the final bits and pieces, then I'll stick a thread up ;D
just noticed Tim m8, you need a spring guide in the hammer spring
KevG
Quote from: KevG on February 03, 2022, 09:31:25 PM
Quote from: Tim_B on February 03, 2022, 12:41:06 PM
So Kev and Dr Bob have never let me down, and they have done it again......2 packages arrived today......
Just waiting on the final bits and pieces, then I'll stick a thread up ;D
just noticed Tim m8, you need a spring guide in the hammer spring
KevG
Hey KevG,
Set him with a DoubleTap Guide!!!
Stuart
Kev - you have a good eye......
Ca - thats an excellent idea 8) ;D