Print Page - Expected adjustment range Raw

Title: Expected adjustment range Raw
Post by: Aggy on January 17, 2022, 07:49:32 AM

This is a bit of a hypothetical question As I haven't done it yet but.
Assuming we are running fac and in .22 what kind of fps spread could be expected using only the hammer adjustment ,it's a bit of a faff to adjust the reg.

Title: Re: Expected adjustment range Raw
Post by: KevG on January 17, 2022, 04:32:10 PM

you do have a fairly wide power band if the reg is set for standard fac.depending of barrel length.but you can adjust via the hammer tension between 26 and 32 ftlbs.main thing is to make sure you are not thrashing the reg
KevG

Title: Re: Expected adjustment range Raw
Post by: maxtich on January 17, 2022, 06:50:23 PM

That's very clear Kev..but what do you mean Thrashing the reg?

Title: Re: Expected adjustment range Raw
Post by: Aggy on January 17, 2022, 07:58:33 PM

In basic spec.22 the Raw should do 50 ftlb that's enough but would like to take it slightly higher and drop slightly lower just for flexibility,If I need any more than that it's either my Fx impact or rimmy

Title: Re: Expected adjustment range Raw
Post by: KevG on January 17, 2022, 08:45:57 PM

Quote from: maxtich on January 17, 2022, 06:50:23 PM
That's very clear Kev..but what do you mean Thrashing the reg?

its when the reg is giving its maximum power but you try and get more from it by uping hammer pre load.you just end up with no extra power but just waist air
KevG

Title: Re: Expected adjustment range Raw
Post by: Aggy on January 17, 2022, 09:02:24 PM

Anyone making reg testers for the Raw yet ,or is easier to screw a gauge into the block

Title: Re: Expected adjustment range Raw
Post by: maxtich on January 17, 2022, 10:14:55 PM

Cheers Kev ..I'm getting it now.

Theoben Rapid Forum

Theoben General Chat Area => RAW, Impact, and All Rapid Derivatives => Topic started by: Aggy on January 17, 2022, 07:49:32 AM