Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: angrybear on December 26, 2021, 02:51:31 PM
When you screw the reg core in to the body how do you know when to stop ?
It has the "spacer" O ring but there's a full turn or more between contact & unable to turn further.
I ask because I've just had to change the little bottle seal O ring on the pip & the core moved which has mucked up the power,
It's now only giving 5ftlb so obviously something is set-up wrong
as long as you have slight travel on the core its fine.you don't want more than 1mm travel though.besr way to check this is to remove nut and bellevilles
KevG
Could you explain that a bit more Kev, I don't follow what travel you're on about :-[
I thought it all went in 'snug' with only the compression of the spring washers by the air pressure to allow it to open.
the core should have travel.you should be able to push it in and out when nut and bellevilles are removed.if it had no travel at all you would get reg lock
KevG
Ok, I think I get it,
So I'm obviously right at the point of reg lock because the slightest turn of the core changes the muzzle energy,
half a turn & the gun will not fire.
I assume that means I need to remove the nut & washers then screw in the core to get the fractional movement & re-fit/adjust the washers ?
Right job done,
just a fractional movement of the core shaft,
reassembled set to 100 bar (.20 cal)
Not creeping up & not leaking with bottle removed :) :)
So I guess that's pretty much what it should be doing 8)
Thanks Kev, I now understand ;)
reset as it was just a wee bit hot :o
now giving a steady 677-685 fps over 3 mags, with FTT's
5 mags for the whole reset dropped the bottle from 200bar to 170bar so reasonably frugal with the air ;D ;D