Just ordered a reg for my mk1 and wanted to know whats the recommend pressure setting?? . 22 cal 12ftlb..
TIA..
depends whats been done to the mk1 to take the reg.if its a very late mk1 2007 or after its 1200 psi.if its an ebay one thats advertised as mk1 reg they are not actually for a mk1.
KevG
You should have got one from kevG .md
:-\ oh dear... Ebay special.. The block is 1995.. 🙄
its my fault rapid dee sent me a pm on the 13th asking about a reg and only just seen it last night.my apologies
KevG
sorry mix up it was rapid7bee that messaged me
KevG
Thnx Kev.. So is 1200psi still the pressure to use..?
Cheers.. Ho ho ho 🎅
yeahhh same pressure ...but the early block isn't ported for a regulator.
The thread blocks the R7/mk1 port between inlet and valve chambers.
Kev's reg has a waist and hole to line up with the port..
Smaller port for sub-12 fastflow at front...modified with 2nd port for reg.
Can be DIY but one slip and it's buggered.
I set them at 1350 psi if the mk1 is all standard.this gives you around same shot count as a mk2 but slightly better shot to shot consistency. would not realy know what to say for ebay one.if you port action as per mk2 so Ebay reg works at its best I would go 1200 psi.if you just put Ebay reg in to a standard mk1 block performance will be poor.you should still be able to get 12 ftlbs but gun will not be very efficient ie poor shot count.
KevG
Thanx you 2 for that info.. I have messed with the ebay one but cant get it anywhere near 1200psi.. How much is yours kev ready to screw in?
Thnx
thats strange you should be able to get that pressure easy.i would try doubling up the bellevile washers.like this (())(())(()) as opposed to this()()()()()
KevG
Theres only 7 washers on it Kev..
It came like this () () () ( nut.. I have tried removing a pair and then replaced them like this.. ) () () () nut.. I got it to read 11000 psi briefly but it didnt last before it went back to bottle pressure.. I think the little nylon pip that seals the inlet that aint blocking the inlet flow.. I'm gonna go back to fast flow..
🤔
Well someone has pulled a few washers off of the Reg...
You need to get KevG to sent a few over...
To configure it to :....(())(())(())
!!
Stuart
Theres not enough room to get 12 washers pn it... I said 7 earlier, i wad wrong, there's actually 5.. 😐
Quote from: Ca_Varminter on December 26, 2021, 08:50:18 PM
Well someone has pulled a few washers off of the Reg...
You need to get KevG to sent a few over...
To configure it to :....(())(())(())
!!
Stuart
if it crept up to bottle pressure it as creep to or open reg.
KevG
should be six washers on those and the one I had was close to bottoming out on the threads at 90 bar.
May be able to lift the stack with an M6 washer.. should be able to get 5 to the required pressure but fewer washers make it harder to set.
However the end float needs setting quite short 0.5 mm
I think its just open..
There's various thickness in these disks are them disks thicker
normally they are 0.5 mm but some are 0.7mm
KevG