Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: GB2017 on November 23, 2021, 06:05:52 PM
Evening
I have a 20 cal barrel that I was looking to out, someone has said that they wanted it if it was a sub12 not fac version
How do I tell the difference, assuming its the porting, this one is circa 2x4mm oval (dont have any verniers at my disposal)
TIA
How long is the barrel?
Not uncommon for .20s to be 19" to squeeze out the efficiency.
sub-12 porting is about 3mm / 7 square mm
2x4 oval has the same area
2.5 x4 is still only 7.8
Depends what block it's going in- shouldn't be a problem if the buyer is capable of setting up right to start with.
A sub-12 mk1 would still be limited by the block porting and valve and a .20 needs a little more flow.
Slightly larger (2.5mm or more ) would be better with a reg or mk2, which will breath easier
Having said that I've had my FAC .22 running sub-12 with good consistency, the blocks FAC mk2 fast-flow spec with a 22" barrel and 3.5x6 18sq/mm porting ;)
Thanks Barrel is 15.75"
You're welcome.
In the end its going to be about how the buyer sets it up,
My .20 sub 12 MFR barrel has a 4mm port.
I run a 12" barrel on my .20 mk1 and the porting is 4mm - its running at 620 with jsb exact
So spot on 11.7 👍
to be honest I never measured the port size on my .20 when it was stripped down.
My mk2 177 is 3mm, my sub-12. 22 is 3mm and the 20 looked about the same.
4mm..... both regulated and one quite short.
Thanks for the help Gents
Barrel is sold so primary objective achieved !!
Quote from: GB2017 on November 24, 2021, 08:15:23 AM
Thanks for the help Gents
Barrel is sold so primary objective achieved !!
nice one 👍