Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Wolf on October 13, 2021, 06:05:15 PM

Title: MK1 power/consistency, bottle pressure
Post by: Wolf on October 13, 2021, 06:05:15 PM
Stuck my Rapid 7 over the chrony this afternoon, bottle pressure roughly 120 bar, 12 shots with 5 to 7fps variation, at max 11.7 ftlb with accupells, to the best of my knowledge the gun isn't modified in any way, has no reg, just the short early bottle adaptor. Very pleased to say the least.

Filled the bottle to 160 bar roughly for a comparison of power curve, power dropped slightly as expected, and pellet speed down to high 577-585 ish, around the 10.7ftlb mark as rough guess, but still giving under 10 ft per sec spread between shots. 

Are they usually like that? :o
Title: Re: MK1 power/consistency, bottle pressure
Post by: Squinty on October 14, 2021, 04:58:06 PM
Sounds quite low, usually the power curve  is on  the sweet spot around 180 bar.

I'd check again at 80-90 bar to see if the power continues to rise.

Often the problem is no power curve, starting high with a constant drop, tends to be a weak stem spring letting the air run free.

I'm throwing a couple of  gueses that either the spring is too stiff or maybe its fitted with a larger reg type valve which is shutting off too quickly with higher pressure from the fast-flow. Power rises as it gets closer to optimal pressure.
Title: Re: MK1 power/consistency, bottle pressure
Post by: Wolf on October 14, 2021, 08:33:07 PM
I'll give that a try and see what it does. :)
Title: Re: MK1 power/consistency, bottle pressure
Post by: KevG on October 19, 2021, 11:03:36 AM
would also check valve body front port for size.needs to be 5mm
KevG