Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Wolf on October 05, 2021, 12:35:35 PM
Hopefully not too dumb of a question, is there an adjustment for holding the mags into the block, ive got an original 12 shot one that sort of clicks into place and stays put, and a dr bob version that almost falls out when i tip the gun over to the left, wondering am I missing something?
That is very odd indeed that one fits tight and one is slack.
never heard of a problem with a Dr Bob mag before.
I would say if both were slack then yes adjust the barrel clamp.
Im sure someone will also give advise on this.
Regards kev.
The thickness of Theoben Mags has varied from Lot to Lot!!
I know Dr Bob's mags he took an average of the thickness's!!
You can adjust your barrel, so the loose mag is fits better...
Or you can talk to Dr Bob... He may have lids of different thickness!!
Stuart
Theoben tolerances :(
Two options I've used-short of another magazine or moving the barrel back...which won't help the one that fits.
Shim the front face with tape or glue some thin plastic it, I used laminating film as it's very consistent in regards to thickness and hard
Or the old AWT/ Ian Collins way and use a soldering iron to creat raised contacts. Haven't found any 12 shot mags that are tight in my 006*** Rapid 7 block
Can either push the mag in whilst still hot or shave back with a Stanley blade.
Cheers, I'll try and shim it up first then I reckon, hopefully that will do the trick.
I'd snug the barrel on the loose one & rub down the tight one on some wet & dry to make it fit.