Hi All
Can anyone help I have a slow leak coming out of my barrel. Is this likely to be the valve?
Any help would be grateful
When I had that problem last year it was seals on the valve.
Regards kev.
Will be either the valve body o-ring (s) or the valve stem seat.
Could be hammer spring pre-load if that's been wound in.
Cheers folks
I have just put in new hammer spring so maybe that
Quote from: Deckchair on September 28, 2021, 07:05:21 PM
Cheers folks
I have just put in new hammer spring so maybe that
That should not cause a leak down the barrel on a full bottle...
Maybe on a bottle with a low Amount of air...
The area to check on the Valve-body...
(https://photos.imageevent.com/scl_electronics/gun/air/websize/air%20leals.jpg)
The face of the Valve-body for any defect or debris.
The large O-ring on the valve-body for defects, dried lube, or just being Dry!
Finally the Valve-stem itself!
Roll the valve-stem on a flat surface to see if it bent!
Good Luck,
Stuart
I had this problem once or twice and found that mostly it comes from the main valve body,....Now when i fixed this problem i smoothed the top of the valve body off where the valve stem connect`s to it and all was good and it sealed again,
Normally dust or grit get`s in and spoils the main valve body seating head for the stem and create`s a gap for the air to leak through,
Hope you get it sorted soon M8, keep us posted!
:)