Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Grumps on September 23, 2021, 02:54:43 PM
My mk1 rapid has it's original bottle, although I have replaced the valve with a Michael Tawn valve, it has two dates stamped on it, 1987 and 01/97.
I'm guessing one is manufacturer and the other expiration ?
Has anyone had one catastrophically fail ?
I'm prepared to concede that it might be time for a replacement, what are the best options for a 0.4 L bottle?
No I have never heard of a Rapid Bottle failing...
There is enough of a safety margin by the manufacturer, you should never have a problem.
The One Main exception is Physical Damage!!!!
The only Catastrophic Failure that I can remember..
Was An Aluminum Airtube exploding .. when a stock maker was working on it....
I don't remember the Stock maker's name
Stuart
1987 is part of the British Standards specification, should read 'BS 5045 Pt.6 1987'
Manufacturing date will be along the lines of 1/97 or 08/2002
Two things to look out for when changing the valve.
a) the M18 threads in the neck are intact and have no corrosion
I scrapped one a few years ago when I found that the bottom quarter of the threads had disintegrated.
b) the inside of the bottle is clean and corrosion free..white n crusty is not good ..to start with the Aluminium oxide can damage bottle or exhaust valve surfaces.
And again I chopped a bottle that came with a Rapid, after both valves failed and on replacing the bottle valve a teaspoon of the crusty stuff was tapped out.
Thank you chaps, I shall continue using the original in this case.
Menu years ago ther was a bsa bottle that exploded when being filled with a hand pump due to oil mine are that old and only fill with air from dive bottle I've got 3 2 280cc 1 bsa 200cc one bottle has the oridgernal schrada valve in even though l have 2 new ones and works on my reg as I have plugged the centre hole in the push pin