Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: cliff8 on September 20, 2021, 08:01:01 PM

Title: Parr. 008 mounting
Post by: cliff8 on September 20, 2021, 08:01:01 PM
Can anyone tell me how to mount a parr 008 to my theoben m f r ??
Title: Re: Parr. 008 mounting
Post by: angrybear on September 20, 2021, 09:38:57 PM
Get an extended picatiny rail, mine was Dr Bob's I think, then you probably also want a decent mount preferably with some height/angle adjustment.

I could never get mine angled down enough & ran out of adjustment, but I didn't waste money buying a better mount because I don't think they're any good as a day scope,
so I sold it on & kept my Wardy add-on.
Title: Re: Parr. 008 mounting
Post by: cliff8 on September 20, 2021, 10:22:27 PM
Thank you sir. Not worried about using it for a day scope. Will be used only at night in poultry farm. Disappointed that you couldn't get it to zero though. How about an a t n ??
Title: Re: Parr. 008 mounting
Post by: Ca_Varminter on September 21, 2021, 12:39:40 AM
Don't worry about running out of elevation when Zeroing!!
Normal with the Rapid..even with standard scopes!
If you need more elevation, just shim the rear ring. Between the bottom half and the scope.
Or shim under the rail close to the rear mounting bolt!!

Stuart
Title: Re: Parr. 008 mounting
Post by: Dr Bob on September 21, 2021, 09:26:37 AM

I'm hoping a new batch of dovetail rails and weavers will be ready this week.

Bob
Title: Re: Parr. 008 mounting
Post by: angrybear on September 21, 2021, 11:11:21 AM
Hi Bob,
have you ever considered getting a few rails made with 20 moa, to help zeroing digital NV/scopes  ;)
Title: Re: Parr. 008 mounting
Post by: rgc_swanseaARC on September 21, 2021, 11:18:28 AM
Buy the Eagle vision mount of the ZB Lite Pro and put it on the standard sized rapid picatinny rail.
Make the whole process easier.
They are a faff to set up but once done you have a centralised reticule without having to go huge on the x and y co-ordinates.

I use the EV mount with the Pard NV008LRF on my Daystate Pulsar....it is deadly!

Regards,
Rhys
Title: Re: Parr. 008 mounting
Post by: cliff8 on September 21, 2021, 11:33:20 PM
Thank you Rhys and Stuart for your kind advice. I'll think Dr Bob can sort out my mount problem. Hopefully 🙏
Title: Re: Parr. 008 mounting
Post by: Dr Bob on September 23, 2021, 11:01:12 AM
Quote from: angrybear on September 21, 2021, 11:11:21 AM
Hi Bob,
have you ever considered getting a few rails made with 20 moa, to help zeroing digital NV/scopes  ;)

Yes and it just wasn't a viable proposition :'(
Title: Re: Parr. 008 mounting
Post by: KCE on September 23, 2021, 01:08:41 PM
Here you go m8.

Regards Kev.
https://www.ebay.co.uk/itm/165078332527?hash=item266f6f746f:g:flgAAOSwl9BhRSRA