This looks a handy tool for in the spares box .
Anyone on here use one or make similar?
(//)
Rich
I purchased one a little while ago, was ok on two regs, the third (an Ebay reg) that was on my .20 ..I had to take a touch off the pins as it juuust wouldn't line up.
I made my own for my work but don't bother to make for selling because of the reason above,as the location holes can differ in the regs.had a few regs sent to me with damaged push pin disc because of some of the reg tools.
KevG
Hi guys,
I got one as it's damn near impossible to swap over the "O" ring on the MFR bottle probe without it.
It has a secondary use, however, as it's spot on size for getting the split nut on the stock screw of an S200 off as well.
I then swpped the iditic screw for a long 6mm stainless steel item on both my S200's
Sandy
Well I got one & tried to use it for the first time this morning & one of the pins has failed :(
not happy at the moment.
That aint good at all m8.
Can you send it back ?.
Regards kev.
Well I would hope for either a replacement or refund,
It's literally only just happened so I've messaged the seller & sent them a photo and await their reply.
TBH I'm more concerned with sorting out the reg holder for the rifle. :'(
Instant refund from the seller, who turns out to be Rob Lane,
I ended up having to drill it out & use a No3 screw extractor :'( so no blame on the tool for failing.
A good out come m8.
Glad to hear you well on your way now with problem all sorted.
Regards Kev.