Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Daztilley on April 30, 2021, 04:42:21 PM
Got a 280cc buddy bottle I've had for a while - but haven't used. The oring had gone between the bottle and the valve and wouldn't hold any air at all.... the problem was that its a shrader type valve with no cutouts 😡
I bought a 50mm hydraulic hose clamp from ebay to hold the bottle tightly in the vice without damaging it. Blow torch on the bottle valve to destroy the loctite that theoben always used...
Mole grips on the valve body and a bit of brute strength and the valve was unscrewed 👍
In the pic you can see they used loctite the full length of the thread - the o ring that was leaking had gone rock hard and looked like a bakelite washer 🤣
Atleast I can now fit a new o ring and valve and use the bottle 👍
I would check the interior of your bottle for corrosion!
That doesn't look like thread lock......
Lookin at the top thread.. and the rest of the threads..
It look like Corrosion!
The Whitish residue is aluminum oxide, possible due to galvanic corrosion!
Due to the presence of water!
Stuart
Yes checked inside using a torch and inspected the valve thread in the bottle neck - fine and un damaged with no sign of any residue or corrosion inside the bottle. Looks like the valve had never been removed as they made the early shrader valves a permanent fixture