Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: nevadacowboy on April 17, 2021, 06:22:22 PM

Title: Rapid zeroing problems
Post by: nevadacowboy on April 17, 2021, 06:22:22 PM
I fitted a new scope to my .177 rapid today and decided to use a set of half moon risers to give me a better head position. After fitting the scope i could not get it to zero at 30yds, I ran out of elevation.


To cut a long story short the problem was down to the scope risers, they were two different heights and I had another pair just like them in my spares box

If you have more than one set of scope risers make sure they are a matched pair and keep them together. It took me ages to find out what the problem was
Title: Re: Rapid zeroing problems
Post by: Tim_B on April 17, 2021, 06:51:48 PM
Two sets, how decadent :D

Interesting though, so thanks for sharing.
Title: Re: Rapid zeroing problems
Post by: Squinty on April 17, 2021, 07:45:38 PM
I'll remember that useful tip..... as I have two 'pairs' of 30mm half moons in the same bag.
Title: Re: Rapid zeroing problems
Post by: KCE on April 18, 2021, 03:09:53 PM
Thank you for the heads up most appreciated.

Regards kev.
Title: Re: Rapid zeroing problems
Post by: Fergie777 on April 20, 2021, 12:23:20 AM
Put the thicker of the two on the rear mount, angles the scope down towards
the barrel, giving you more elevation adjustment.