Theoben Rapid Forum

DrBob`s products & parts => Dr Bob's Section => Topic started by: Deckchair on February 25, 2021, 04:32:36 PM

Title: Hammer adjustment screw
Post by: Deckchair on February 25, 2021, 04:32:36 PM
Cheers Bob
Fits a treat
Title: Re: Hammer adjustment screw
Post by: Dr Bob on February 25, 2021, 06:02:22 PM

There were complaints ( from the usual suspects) that the adjuster in the back of the Vendetta's were a tad sloppy this was NOT under spring tension ...So I had 100 made .03 mm oversize and supply them with the action free of charge. Guy complained that it wasn't right that a standard one didn't fit even though he'd been given one. It cost me over £400 to get the oversize ones made.

I can turn the oversize one down to fit the standard one in a jiffy.

Bob
Title: Re: Hammer adjustment screw
Post by: KevG on February 25, 2021, 07:21:44 PM
even same on some of the genuine theoben blocks and plugs bob.some fit different to others.
KevG
Title: Re: Hammer adjustment screw
Post by: Dr Bob on February 25, 2021, 10:43:49 PM
That will be all my fault too then😆😆😆