Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: kena on February 02, 2021, 08:51:00 AM

Title: Stock cut out
Post by: kena on February 02, 2021, 08:51:00 AM
Gents, a bit of trivia which has left me with a question
I recently sold a very late Mk1 with the scalloped block and Mk4 trigger. It had a small power cut out in the top of the stock. The cut out was about 7mm wide and although it was very neatly done, and looked as if it had been cut out by a machine, to me it had ruined the stock. Does anyone know if the cut outs were done as a factory option
Title: Re: Stock cut out
Post by: KCE on February 02, 2021, 08:54:47 AM
I would say no if you are talking about the rear of the stock to adjust the power levels.

They were either sub 12 or fac so ne need for cut outs.

Regards kev.
Title: Re: Stock cut out
Post by: Mattb on February 02, 2021, 10:21:58 AM
I ordered an ambi stock direct from Theoben for my mk1 rapid and that came with the small cutout
Title: Re: Stock cut out
Post by: Therapidman on February 02, 2021, 04:29:58 PM
Custom stocks would answer that question as they made the stocks and there on here
Title: Re: Stock cut out
Post by: KCE on February 02, 2021, 04:49:46 PM
I have spent many an hour with Richard at custom stock never seen one of there stocks with a cut out.

Regards kev.
Title: Re: Stock cut out
Post by: Ca_Varminter on February 02, 2021, 04:58:30 PM
Well with the intro of the Anti-Tamper plate.... the access to the hammer pre-load was not very important.
Only FAC and exports, saw this option.....

Stuart
Title: Re: Stock cut out
Post by: Mickyd on February 02, 2021, 05:15:34 PM
I also think it looks a mess, people carry a Allen key to turn up or down if plod comes along. Md
Title: Re: Stock cut out
Post by: Ca_Varminter on February 02, 2021, 06:11:25 PM
It was really wasn't made to change the power in the field...
It there to make it easier to tune your Rapid.....
So you didn't have to take the stock on and off, as you tuned you rifle...

Stuart