Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Bumpkin on January 04, 2021, 06:32:42 PM

Title: Suitable moderators
Post by: Bumpkin on January 04, 2021, 06:32:42 PM
Hi,
A bit of help please if anybody can. I recently bought a late model Rapid Mk1 with the barrel threaded 1/2 unf. It didn't come with a silencer so I am trying to locate a Theoben one for it. Am I right to think that the slip over models will fit as well as the threaded ones?
Thanks in advance
Bumpkin
Title: Re: Suitable moderators
Post by: KevG on January 04, 2021, 10:56:08 PM
you may find the holding grub screw will fall onto were the barrel shoulder is towards the thread.
KevG
Title: Re: Suitable moderators
Post by: Bumpkin on January 05, 2021, 02:11:59 PM
Thank you KevG. I guess that means a slide over should work but the grub screw will potentially spoil the thread.  I'll have to be careful - don't want to put another make of silencer on it - just like the shape/ lines of the Theoben - and the idea of it all being original manufacture.
Thanks again.
Title: Re: Suitable moderators
Post by: Squinty on January 05, 2021, 04:41:50 PM
One issue that comes to mind....usually ? the slip-ons use the o/d at the crown to locate centre, being 1/2" and not 15.75mm there may be some play which could push the alignment out. Might end up clipping.

TBH a HW would be lighter and quieter.
Title: Re: Suitable moderators
Post by: Gudge on January 05, 2021, 07:02:46 PM
I guess at a push you could have a sleeve turned up with the 1/2" UNF internal thread and the same outer diameter as the barrel. Just a thought.
Title: Re: Suitable moderators
Post by: Squinty on January 05, 2021, 08:37:52 PM
could possibly use a thread protector but it might need turning down a few thou and centering.

Title: Re: Suitable moderators
Post by: KevG on January 06, 2021, 12:34:08 AM
I would check were the grub screw falls.it may just clear thread if its a short thread run.other wise like already said fit a threaded sleeve just slightly over sized diameter then turn down to barrel diameter
KevG
Title: Re: Suitable moderators
Post by: Bumpkin on January 06, 2021, 07:09:56 PM
Thanks all.  I didn't know beforehand about the thread protector.  It turns out that one has turned up which comes with a threaded sleeve so fingers crossed it will all work fine.  I hope!
Title: Re: Suitable moderators
Post by: Bumpkin on January 06, 2021, 07:12:31 PM
PS I agree re the HW or similar silencer being a better/ simpler option.  My only reason for wanting to fit a Theoben was for originality and the sleek lines that they have. 
Bumpkin