Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Brizza1982 on December 17, 2020, 09:41:42 PM
This all started in 1995 with a Theoben Fenman which I loved and sold for a Rapid mk1, I went to Uni and the gun didn't get much use. Couple of years (2012) later I got back into shooting again and decided to sell the mk1 and bought a mk2 in a ttr stock... £1200 rings a bell and I picked it up from the Theoben stall at a midland gun show. I shot the gun and it was shite, the finish terrible... then I got put in touch with Mr. Genders, the TTR is blooming amazing now, all the internals changed out, the barrel reworked. However I wanted to fac the rifle and knew this would destroy the value so on the hunt I went for a cheap rapid I could fix up and ask Kev to "bless" on examination this new fac rapid had been molested to say lightly and the gun had a horrible fill valve drilled into the block. We decided the gun would be too dangerous to resurrect so here I am having just ordered an impact and a dr Bob block to see which is the most suitable! Appears the impact has a dovetail rail on it so trying to find a piccatiny rail conversion that has a gap for the mag might be fun. Pic rail is a must for me as I run a pard nv008 for night shooting
welcome Ian.glad you made it ok m8.
KevG
Cheers matey, really looking forward to getting out with rebuilt gun :)
Welcome to the forum Brizza1982.
Good to have you onboard.
look forward to reading your postings on here in time.
Regards Kev.