Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Kernal on December 15, 2020, 09:43:29 PM

Title: Theoben Rapid Adjustable Valve..
Post by: Kernal on December 15, 2020, 09:43:29 PM
Theoben Rapid Adjustable Valve..
Stainless steel .
Cap included as in picture.
You can still fit 26mm shroud with this valve.
This give a better tune between hammer and valve timing.saving the need to sorce different valve springs .

Anyone know what this is all about i found it listed on ebay for £65 pounds.

Title: Re: Theoben Rapid Adjustable Valve..
Post by: KevG on December 16, 2020, 01:05:09 AM
can not realy see the point in them my self.as long as you have a decent stem spring fitted gun should run fine.nothing wrong with the standard theoben spring though I do them 1.5 mm longer.which tends to flatten the power curve slightly better on un reged guns.
KevG
Title: Re: Theoben Rapid Adjustable Valve..
Post by: Kernal on December 16, 2020, 08:37:14 AM
So on the early Mrk1`s if you fitted a stronger or a decent stem spring it would or could flatten that horrible power curve it has,....if so by how much as when i had my mrk1 unregged it was or had a horrible power curve.
If i remember the power curve could go from 11lbs to say 15 lbs at peek,...That was until i got you to fit your regulator :D i never even give the power curve a thought after your reg tbh.

:D
Title: Re: Theoben Rapid Adjustable Valve..
Post by: KevG on December 16, 2020, 11:39:33 AM
no thats different in your guns case.it did not help matters because of longer barrel and to large a port which magnified the power curve. a normal curve should start at around 11 ftlbs and climb to around 11.7 ftlbs
KevG