Theoben Rapid Forum

As above can they be fixed? One I have the little nub on the pellet holder 'star' (the black bit)that contacts the clear front plate to pull it round so you can tention it for loading is damaged and slips preventing me from loading the mag at all 

I fixed 1 with the same problem a while ago....

Strip the mag and remove the wheel...
Drilled a hole in the wheel where the plastic stop used to be with a 1mm drill bit - then push fitted a panel pin into the wheel. The panel pin is then trimmed to be just proud of the wheel.

Rebuilt the mag - sorted 👍

Quote from: Daztilley on November 14, 2020, 01:27:36 PM
I fixed 1 with the same problem a while ago....

Strip the mag and remove the wheel...
Drilled a hole in the wheel where the plastic stop used to be with a 1mm drill bit - then push fitted a panel pin into the wheel. The panel pin is then trimmed to be just proud of the wheel.

Rebuilt the mag - sorted 👍

Nice one daz I was wondering if that was a possible way of doing it looks like I'm looking for tiny drill bits 🤣👍👍 thanks mate!

I have some drill bits that size you can have just pm me address you can have them for free.

Regards kev.

Yes it does the trick and its a hard wearing permanent fix too - saves a good mag too 👍

Quote from: KCE on November 14, 2020, 04:07:12 PM
I have some drill bits that size you can have just pm me address you can have them for free.

Regards kev.

Nice 1 kev 👍😎

Quote from: KCE on November 14, 2020, 04:07:12 PM
I have some drill bits that size you can have just pm me address you can have them for free.

Regards kev.

Sorry kce not been on in a while long story work related 👎👎👎 thanks for the offer mate! I'll ping you a pm if the offer still stands?

Hi Remchester

You are welcome to ping me and yes the offer still stands.
Regards kev.