moded tm1000 hammer.so much run out it could not be turned down to make true so made it in two sections with a larger inner bore.cured the problem on this one.
KevG
Once again you never seem to amaze me Kevg.
Another cracking job and a good idea.
Regards Kev.
Impressive Work as Usual KevG!!
I sort of like the contrast of brass and steel....
So is RAW/TechForce CNC lathes not running true?
Sad that their Quality has slip since being sold!!
Stuart
very hit and miss Stuart m8.known early and late tms have the problem.its not just pip run out but on some of them you can see the forward portion(after cocking collar)osalate when run in a lathe.i wonder if the case hardening proces does some thing to the hammer were its very thin walled.
KevG
actually was just a dummy run in brass but it worked that good and improved things for him I left it as it was.better turning brass than stainless 316😁
KevG
Now that is real sad Story....
Since this could be attributed to the hardening of the Hammer!
Because the part needs to be ground to true up and to size!!
So they are saving a couple of $$!!
I spoke to Chip Smith, when he was doing his custom one off Parts!!
He Told me he made special spinning Jigs for hammers and Bolt bodies!
So He would spin grind all his harden parts to spec!
Just a Sad Story....
Cheers M8 for the some Great Info, as usual!
Stuart
Quote from: KevG on November 13, 2020, 02:51:13 PM
moded tm1000 hammer.so much run out it could not be turned down to make true so made it in two sections with a larger inner bore.cured the problem on this one.
KevG
Cracking work kev mate! You never stop with the amazing stuff you do I'll be back over when I can for some more work on one of my mk2s reg is knackered
Superb work as normal Kev 8)
Brilliant work Kev - do like the contrast between the stainless and brass too 👍
Did it add any weight to the hammer?
its same weight daz.just moded it to make it straight😁he is a top completion shooter on the 25 mtr bench rest.if pellet hits 1mm of he wants the gun striping.their standards and expectations are very high..
KevG
Must be good if he's doing benchrest mate - top precision for that! Looks a great job on the hammer 👍