Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: smithy123 on October 27, 2020, 09:34:07 PM

Title: Carbon sleeve done
Post by: smithy123 on October 27, 2020, 09:34:07 PM
Well!!! My carbon sleeve has finally arrived and I've managed to get round to doing it l.... here's a few pics of what it's at now

However there has been a bit of a problem the place where I ordered the tube from wich is (katana carbon) has buggered it up. There is a couple of strange markings, and I've scrubbed and scrubbed it with soapy water and I can't get it off. I will be emailing them about this as I'm not happy about it. It should have been checked before sending it out.

Anyway here's a few pics of my rapid now and I'll post a couple of pics of the marks what are on the tube!!!! 😡😡
Title: Re: Carbon sleeve done
Post by: Lewis86 on October 27, 2020, 09:52:52 PM
That's a shame. I had 2 marks like that on mine yesterday but luckily it was towards the end I cut off. Hopefully they will send you a new one out
Title: Re: Carbon sleeve done
Post by: smithy123 on October 27, 2020, 09:55:11 PM
It's not a big issue really mate as how I've cut it it's right up to the block on the bottom facing buddy bottle so you can't see it but I'm still going to email them and get them to send me a new one out, and I won't be paying for it or I'll be giving them a bad review on this forum and I'll be mentioning that to them!!!!!
Title: Re: Carbon sleeve done
Post by: Lewis86 on October 27, 2020, 09:57:09 PM
May just have been a bad couple from the batch. Are you putting anything up against the block where the tube finishes?
Title: Re: Carbon sleeve done
Post by: smithy123 on October 27, 2020, 10:17:07 PM
I've put a rubber o ring in between the tube and the block it stoped the tube rotating round and acts like a buffer
Title: Re: Carbon sleeve done
Post by: Lewis86 on October 27, 2020, 10:53:40 PM
That's ok then. I was surprised how easy it cuts. I was expecting to get a rough finish from cutting.
Title: Re: Carbon sleeve done
Post by: Bearded Sniper on October 28, 2020, 06:35:51 AM
The barrels look mega carbon sleeved! I've had two tubes in the past both with slight defects in the weaves. Hard to spot initially but once you do they're hard to ignore!
Good ol China QC  ;D