Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Maxwell on October 21, 2020, 04:46:02 PM

Title: Cleaning a rapid barrel
Post by: Maxwell on October 21, 2020, 04:46:02 PM
How often do people clean the barrel on their sub12 rapid and what method do you use
Title: Re: Cleaning a rapid barrel
Post by: The Robin on October 21, 2020, 05:09:58 PM
I use a pull through, thread it in at the muzzle end (a straw helps, I just push it in steady and thread the pull through into the straw and it should find its way to the barrel). Once threaded through it pops out the other end by the probe. I then use lint free cloth patch (buy a pack on the bay for little money, just cut them up into patches and way cheaper than buying pre cut ones). I spray the patch with barrel cleaner (can't remember the name). Pull the pull through back through the barrel in a steady controlled manner.

Once patch has been pulled through if dirty get a clean one and repeat it all over again. Others may do it different but this is the way I do mine. Also the gun is never cocked so fully safe
Title: Re: Cleaning a rapid barrel
Post by: Ca_Varminter on October 21, 2020, 05:32:51 PM
I clean my barrel when the accuracy falls off a bit.
I use a pull-through setup call the PatchWorm...
http://www.patchworm.com/index.htm (http://www.patchworm.com/index.htm)

But once a year when I do my annual tune-up.
I pull my barrel and will use my CarbonFiber cleaning rod.
I give her a proper cleaning!!

Stuart
Title: Re: Cleaning a rapid barrel
Post by: Brooksy on October 22, 2020, 07:24:18 AM
I use a patch and a spray of brake cleaner pulled through with some heavy fishing line.
Title: Re: Cleaning a rapid barrel
Post by: Maxwell on October 23, 2020, 10:39:55 AM
Is wd40 or carb cleaner any good to put on a pull through patch for cleaning barrel
Title: Re: Cleaning a rapid barrel
Post by: bob4026 on October 23, 2020, 07:51:13 PM
WD40 i'd say not, its a water displacement liquid (hence WD), but carb cleaner is very much like brake cleaner. Bit harsh but if it's heavily soiled with lots of crud in the rifling, a squirt won't hurt ten  ins before pulling thru.

Napier gun cleaner spray is very good and there's no need to worry that it's the correct formula for what you are doing.

atb

Bob