Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Kernal on October 12, 2020, 08:15:04 PM

Title: SNNC 334 P1 Rapid 7 Air Rifle Repair . Landy Axle Shims
Post by: Kernal on October 12, 2020, 08:15:04 PM
See what you all think of this repair job,...Video below!

https://www.youtube.com/watch?v=chLq22_lBgI
Title: Re: SNNC 334 P1 Rapid 7 Air Rifle Repair . Landy Axle Shims
Post by: Ca_Varminter on October 12, 2020, 09:06:31 PM
HeliCoil repair is not an uncommon Thread Repair for someone's screw-up!
I use HeliCoil for a lot of thread repairs.... mostly in steel...
For Aluminum, there are better inserts for Repairs....
But each Machinist has there Preferences!!!!

Stuart
Title: Re: SNNC 334 P1 Rapid 7 Air Rifle Repair . Landy Axle Shims
Post by: JoeB on October 20, 2020, 12:56:28 PM
Quote from: Kernal on October 12, 2020, 08:15:04 PM
See what you all think of this repair job,...Video below!

https://www.youtube.com/watch?v=chLq22_lBgI

I was wincing when that screwdriver tip was nearly scratching the action whilst trying to remove the helicoils.
-Im also not too sure I would like to open the hole diameter by 0.1mm just to enable an end-mill.  It would have weakened the threads holding the helicoil and 200bar is not to be messed with!