Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Michael on October 06, 2020, 09:52:56 PM
Hi all my FAC rapid has a custom barrel the gap isn't big enough for a clamp for a bi pod and I don't want to put a stud in the stock and risk splitting it. Is there any other clamps or something I can get like a semi circle.
How Much a gap do you have!
I have a custom shroud on my FAC Barrel.....
Dr Bob, and I had many discussions on his design...
In the End.... No Problem Fitting on my Rapid (Paul Wilsom Custom Cobra Stock)
(https://photos.imageevent.com/scl_electronics/gun/air/websize/rifle3.jpg)
(https://photos.imageevent.com/scl_electronics/gun/air/websize/rifle1.jpg)
Hth,
Stuart
Quote from: Ca_Varminter on October 07, 2020, 12:25:08 AM
How Much a gap do you have!
I have a custom shroud on my FAC Barrel.....
Dr Bob, and I had many discussions on his design...
In the End.... No Problem Fitting on my Rapid (Paul Wilsom Custom Cobra Stock)
(https://photos.imageevent.com/scl_electronics/gun/air/websize/rifle3.jpg)
(https://photos.imageevent.com/scl_electronics/gun/air/websize/rifle1.jpg)
Hth,
Stuart
I had the same issue on one of mine the Dr Bobs clamp wouldn't quite go on but there was a .6mm gap between bottle and barrel, I very carefully filed the top of the clamp flat until it slid on and I could see daylight when tightened on. If you try this make sure you can still see daylight when the gun is resting on the bipod if not you will change.your point of impact. Just file off a little more, you can go very thin on the top they are very strong, if you mess up you can always buy another clamp I'm sure Dr. Bob won't mind.
ATB.
You've got two options according to the Brooksy Ways And Means Act 2019. File or grind the top of the clamp like I did for my modified shroud on the Air Wolf (as Stuart suggested above) or make your own bipod from a B&Q spring clamp like I did for the Rapid and the Air Wolf. The jaws of the clamp can be filed out to a circle of 60 mm diameter and two rods attached to the handles of whatever length you like. The custom bipod cost me about £3.00 and weighs next to nothing. You can unclip it in two seconds and stuff it into your pocket too.
really great idea that and it works a treat for pence
I've got one in the making nice one
I have just had a new batch of thinner clamps made to solve this problem I just need to find another good powder coating firm as my regular one has closed :'(
Bob
HI Dr Bob,
You might want to think about Cerakote..
UltraHard, ultrathin epoxy coating....
Using it on my AR15's...
Baked on, chemical resistant
Check it Out!
Stuart